Body Roundness Index (BRI) Calculator

View results · BRI 3.05

Your measurements

Units
Sex

Measure your waist midway between your lowest rib and the top of your hip bone, usually just above the belly button, after breathing out normally.

Your body roundness

Body roundness index (BRI)

Study group 1 of 5 (BRI 1.05–3.41)

In the 2024 study of 32,995 US adults, this group had a 25% higher risk of death from any cause than the middle group (hazard ratio 1.25, 95% CI 1.05–1.47), after adjusting for age, sex and other factors. These are group averages, not your personal risk.

BRI groups in Zhang et al. 2024

GroupBRIHazard ratio
11.05–3.411.25
23.41–4.451.13
34.45–5.46reference
45.46–6.911.25
5≥ 6.911.49

Same tape, other measures

Waist-to-height ratio
0.48
Relative fat mass (RFM)
22.6%

NICE band: Healthy central adiposity. Below the obesity cut-off for men (30%).

Open the waist-to-height ratio calculator

Screening estimates, not a medical assessment.

About this tool

The body roundness index (BRI) describes how round your body is from two numbers: your height and your waist. Diana Thomas and colleagues introduced it in 2013 by modelling the body as an ellipse as tall as you and as wide as your waist suggests. Values run from about 1 for a long, lean shape to above 10 for a very round one.

BRI drew wide attention in 2024, when a study of 32,995 US adults linked both very low and very high values to a higher risk of death. Unlike BMI, it ignores weight, so it reflects the fat you carry around the middle. This calculator also shows relative fat mass (RFM), a body fat estimate from the same tape measurement, and your waist-to-height ratio.

How it works

Choose metric or US units, then enter your height and your waist. Sex is only used for relative fat mass. Both measurements must be in the same unit: the formulas only see the ratio of waist to height, so centimetres and inches give the same answer.

In the formulas, WW is the waist and HH the height. BRI compares your waist with an ellipse as tall as you: the rounder the ellipse, the higher the index. The fraction under the square root equals (W/H)2/π2(W/H)^2/\pi^2, so BRI is a rescaled waist-to-height ratio. RFM counts sex as 1 for women and 0 for men and gives an estimated body fat percentage.

Your BRI is placed in the five groups of the 2024 JAMA Network Open study, and RFM is compared with the obesity cut-offs its authors proposed in 2020: 40% for women and 30% for men.

BRI=364.2−365.51−(W/2π)2(0.5 H)2RFM=64−20 HW+12×sex\begin{aligned} \mathrm{BRI} &= 364.2 - 365.5\sqrt{1 - \frac{(W/2\pi)^2}{(0.5\,H)^2}} \\[0.6em] \mathrm{RFM} &= 64 - 20\,\frac{H}{W} + 12 \times \text{sex} \end{aligned}

Example

A woman is 165 cm tall with an 80 cm waist, a waist-to-height ratio of 80/165≈0.4880/165 \approx 0.48. The ellipse term is (80/2π)2/(0.5×165)2≈0.0238(80/2\pi)^2/(0.5 \times 165)^2 \approx 0.0238, so her BRI is 364.2−365.50.9762≈3.08364.2 - 365.5\sqrt{0.9762} \approx 3.08: the lowest of the five study groups, below 3.41.

Her relative fat mass is 64−20×165/80+12≈34.8%64 - 20 \times 165/80 + 12 \approx 34.8\%, below the 40% obesity cut-off for women. A man 175 cm tall with a 110 cm waist has a BRI of about 6.09 (group 4) and an RFM of about 32.2%, above the 30% cut-off for men.

How to measure your waist

NICE describes the method in box 1 of guideline NG246. Find the bottom of your ribs and the top of your hips. Wrap a tape measure around your waist midway between these points, which is just above the belly button, and breathe out naturally before reading it.

Measure your height and waist in the same unit: both in centimetres or both in inches. Stand straight, keep the tape level all the way round and snug without pressing into the skin. If two readings differ, take the average.

Who these measures don't suit

BRI and relative fat mass were developed and tested with adults aged 20 and over; the 2024 mortality study excluded pregnant women and people with a history of heart attack, stroke, heart failure or cancer. Don't use them during pregnancy, with an eating disorder or with a condition that affects your height.

All three numbers are screening estimates. They can't tell muscle from fat inside the abdomen, and they don't replace a check-up. If a result worries you, a doctor can look at blood pressure, blood sugar and cholesterol, which matter more than any single index.

Measures that use your weight

Compare these waist-based numbers with BMI, which uses weight and height, and with a body fat estimate from several tape measurements:

Sources

Assumptions and limits

BRI has no official cut-offs. The five groups come from one study of US adults (NHANES 1999–2018), whose authors split people into fifths because no reference range exists. A hazard ratio describes a group average after adjusting for age, sex and other factors, not your personal risk.

The study's middle group, BRI 4.45 to 5.46, matches a waist-to-height ratio of about 0.56 to 0.60, which NICE already classes as increased central adiposity. The two answer different questions: NICE flags the risk of type 2 diabetes, high blood pressure and heart disease, while the study counted deaths from any cause. The authors suggest the higher risk in the lowest group may reflect undernutrition, fatigue or muscle loss, especially after 65, so check your BMI as well.

BRI and RFM were developed with adults aged 20 and over. They are not meant for pregnancy, eating disorders or conditions that affect height. This page is not medical advice; for health decisions, talk to a doctor.

Frequently asked questions

What is a good body roundness index?

There is no official healthy range. In the 2024 study of US adults, the middle fifth, with a BRI from 4.45 to 5.46, had the lowest risk of death, and the risk rose towards both ends: 25% higher below 3.41 and 49% higher from 6.91. For everyday use, the NHS and NICE advice is simpler: keep your waist below half your height.

Is BRI better than BMI?

BRI uses your waist instead of your weight, so it reflects fat around the middle, which BMI cannot see. Its creators found it predicted body fat and visceral fat slightly better than BMI. It is still new, though, and has less evidence behind it than the waist-to-height ratio, which carries the same information and is the measure NICE recommends alongside BMI.

What is relative fat mass (RFM)?

RFM estimates your body fat percentage from height and waist: 64−20×H/W64 - 20 \times H/W, plus 12 for women. Woolcott and Bergman built it in 2018 from DXA scans of more than 12,000 US adults, and it estimated body fat more accurately than BMI. In 2020 they proposed 40% for women and 30% for men as cut-offs for obesity.

Why do other BRI calculators give different results?

Some pages use a wrong formula or mix units. The 2024 JAMA Network Open paper itself published a correction to its BRI formula, which now says to enter height and waist in the same unit. This calculator uses the corrected formula from Thomas et al., and the worked example above lets you check it by hand.

Do men and women use the same BRI groups?

Yes. The study defined the groups for all adults together and adjusted the hazard ratios for sex; women had a higher average BRI than men. RFM is different: it adds 12 percentage points for women, who carry more body fat than men at the same waist and height.

Link with your values

Add these parameters to this page’s address to open it with the values filled in, for example to share a calculation or to link to it from an AI assistant. The result is calculated in the browser: the page HTML shows an example for the default values, and the tool sets the data-url-params attribute once the link’s values are applied.

ParameterValueIf omitted
unitsmetric or imperialset by the first measured value
sexSexone of: male, femaledefault male
height_cmheight_inheight_ft + height_inHeight (cm)number; any unit in the name: _mm, _cm, _m, _km, _in, _ft, _yd, _mi, _nmi; allowed 120–250 cm (metric), 47.2440944882–98.4251968504 in (imperial)required
waist_cmwaist_inWaist (cm)number; any unit in the name: _mm, _cm, _m, _km, _in, _ft, _yd, _mi, _nmi; allowed 20–250 cm (metric), 7.87401574803–98.4251968504 in (imperial)required

Examples

  • ?sex=female&height_cm=165&waist_cm=80
  • ?sex=male&height_ft=5&height_in=10&waist_in=38

Write decimals with a point. Encode a space as %20, + as %2B, # as %23 and & as %26.

Result elements: [data-result-block="body-roundness"]